GKR Baseplates

Baseplates for the game GKR (Giant Killer Robots).
These allow the health of a unit to be displayed on their baseplates rather than unit cards, making it more visible to other players at a glance.

Print instructions

Category: Toys & Games Summary

Baseplates for the game GKR (Giant Killer Robots).
These allow the health of a unit to be displayed on their baseplates rather than unit cards, making it more visible to other players at a glance.

Print Settings

Rafts: No

Supports: No

Infill: 100%

Notes:

Infill can be low but will use basically the same amount of filament but 100% should give the best surface finish

Post-Printing

Unit Bases
To print a HP base for all support units and mercs you will require these quantities:
5 x 1HP base
6 x 2HP base
5 x 3HP base

(You can decide whether or not it is worth having bases for units with 1HP or not as you could just remember that any units without a base have 1HP)

If you have Big Little Buddy you will also require:
1 x BLB

Pegs/HP Markers
If every single unit is in play at the same time (unlikely) you will require:
37 x Pegs

Inserting

The tolerances on these are designed so they fit TIGHT.
To attach base you will need to click in each point of the base one at a time:
1: place rear edge of unit against inner edge that has HP peg holes
2: while slightly flexing the printed base down work your way clockwise by pushing the corners of the unit into the base
3: pegs should push into the holes firmly but may require pushing in and out a few times for goldilocks fit