Kia Niro 17-22 Car Speaker Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom adapter/mount for OEM style/dimensions that is a perfect drop in replacement, specific to JBL Concert and Club.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 284
- Wydruki
- 1
- Wyświetlenia
- 1974
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
“Universal adapter” HKSB110: https://www.printables.com/model/412494-hksb110-car-speaker-adapter-select-2006-2021-hyund
I was disappointed with the adapter plates that came with my Crutchfield JBL Club 602C/622 speakers, as they are hard to seal and are ~2cm shorter, recessing the speaker further away leaving a large gap that opens behind the panel. I'm no audiophile, but I imagine is bad since even the stock speakers are sealed at the mount and press into the door panel with mounting foam.
I'm sure this fits some other Kia/Hyundai vehicles as well.
I modeled these for the JBL Club 602/622 specifically, but I have provided the STEP file for you to remix to your speakers/hardware. Tolerances are fairly tight.
From what I can tell, this will work as-is for all JBL Concert and Club 6.5", except possibly the Club SQ (carbon cone), which has a thicker mounting plate. It seems JL speakers have a very similar mounting plate profile and may fit without major changes.
There is a bottom adapter that takes the Metra 72-7302 Speaker Wiring Harnesses (note it is asymmetrical and "permanent" snap that likely requires breaking the printed adapter to remove the connector). This must be snapped in first, before mounting the speaker as the terminals will be obstructed by the speaker frame. It is actually a very tight fit for wire length as the 622 speakers have tilted tweeters that need an upward orientation.
I ditched the JBL included foam (for the back channel of the speaker plate) as it seems too thin to seal and used 1/4"x1/4" foam tape. (However, you can use the included gasket on the lip instead overlapping the mounting slots, which should work very well without buying additional gasket. You'll need to snip some of the “core”-of-spiral foam to complete the perimeter since it's longer)
Top sandwiches the speaker to the bottom and use the 1" included screws (medium length) to secure the assembly.
Use 3/8" W x 1/4" foam tape to make the surface ring that will mate with the door panel.
https://www.amazon.com/gp/product/B093C1SCG4
For the mating surface with the door, I used cheap caulk rope weatherstripping from hardware store (you could use a thin foam tape as well). Just make sure you add some around the mounting holes! The tabs will crack from the bending force if you do not! (also don't over torque to the door, just enough for a light squeeze on the caulk.
Enjoy the much less muddy sound!
Print with ABS/ASA (duh). 6 perimeters, 25%+ infill, 0.2mm layers. Brim strongly recommended. No supports needed.
Kia Niro door panel removal: crazy simple, only need a trim tool/stiff plastic pry bar and a Phillips screw driver.
https://www.printables.com/model/186953-car-trim-tool-mod
https://www.kniro.net/front_door_trim_repair_procedures-1480.html