1 / 2
4in/100mm Funnel Port for Dust Collection — zdjęcie 1
1 / 2

4in/100mm Funnel Port for Dust Collection

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dust collection funnel port designed to maximize use of the bed of an Ender 3.

Ocena
5 / 5
Polubienia
17
Pobrania
101
Wydruki
1
Wyświetlenia
608
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is designed to maximize the size of the funnel to fit an ender 3 print bed.  It was designed with a contractor/cabinet table saw in mind. It was designed with 4in/100mm hose in mind.

 

I have an old Delta/Rockwell table saw with a big open hole in the bottom (16x18 IIRC). I ripped down a piece of scrap ¼ plywood and used a jigsaw to cut out a 6x6 hole. I set the funnel in the hole, drilled a few pilot holes, and then put in in the saw and screwed the funnel down.

Attach the hose with a clamp and you're good to go! (now to figure out how to cover the rear of the saw without interfering with the trunnion and belt)

 

I've considered adding threads to this design. Alternatively, you could scale my “coupler” design up 2 mm and pressure fit over this and it should still fit the hose just fine.

Tagi