1 / 2
4in/100mm Funnel Port for Dust Collection — image 1
1 / 2

4in/100mm Funnel Port for Dust Collection

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Dust collection funnel port designed to maximize use of the bed of an Ender 3.

Rating
5 / 5
Likes
17
Downloads
101
Makes
1
Views
608
Reviews
1

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is designed to maximize the size of the funnel to fit an ender 3 print bed.  It was designed with a contractor/cabinet table saw in mind. It was designed with 4in/100mm hose in mind.

 

I have an old Delta/Rockwell table saw with a big open hole in the bottom (16x18 IIRC). I ripped down a piece of scrap ¼ plywood and used a jigsaw to cut out a 6x6 hole. I set the funnel in the hole, drilled a few pilot holes, and then put in in the saw and screwed the funnel down.

Attach the hose with a clamp and you're good to go! (now to figure out how to cover the rear of the saw without interfering with the trunnion and belt)

 

I've considered adding threads to this design. Alternatively, you could scale my “coupler” design up 2 mm and pressure fit over this and it should still fit the hose just fine.

Tags