Projector base for coffee table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Basic projector base to increase the angle for a short throw using a C-clamp to attach to the wood panel
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 813
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This model is intended basically to increase the angle of projection of my Epson 1060.
I have installed the projector on an IKEA LUNNARP coffee table with a very short distance (140cm) from the screen, the angle that the projector's foot was providing was not enough, so I made this basic stand to increase it. After I printed a first prototype I realized that there was some room underneath, so I added a small platform to fit an AppleTV, so everything is in the same place.
I printed everything without supports at 20% infill on PLA.
The stamp and platform that holds it to the edge of the table are made by Wilko, you just need to change the parameter size of the c clamps to 15mm to fit this one: https://www.printables.com/model/9182-c-clamp-g-clamp-01-04-smart-infill-better-clearanc
chances are that you don't have Fusion so here they are already resized:
https://www.printables.com/model/413755-stamp-and-platform-resized-to-fit-a-15mm-space-lef