Projector base for coffee table
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Basic projector base to increase the angle for a short throw using a C-clamp to attach to the wood panel
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 36
- Makes
- 0
- Views
- 813
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This model is intended basically to increase the angle of projection of my Epson 1060.
I have installed the projector on an IKEA LUNNARP coffee table with a very short distance (140cm) from the screen, the angle that the projector's foot was providing was not enough, so I made this basic stand to increase it. After I printed a first prototype I realized that there was some room underneath, so I added a small platform to fit an AppleTV, so everything is in the same place.
I printed everything without supports at 20% infill on PLA.
The stamp and platform that holds it to the edge of the table are made by Wilko, you just need to change the parameter size of the c clamps to 15mm to fit this one: https://www.printables.com/model/9182-c-clamp-g-clamp-01-04-smart-infill-better-clearanc
chances are that you don't have Fusion so here they are already resized:
https://www.printables.com/model/413755-stamp-and-platform-resized-to-fit-a-15mm-space-lef