1 / 11
Fully adjustable monitor light bar with RGB — zdjęcie 1
1 / 11

Fully adjustable monitor light bar with RGB

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Monitor light bar with RGB CCT led strip, wirelessly controlled from desktop.

Ocena
0 / 5
Polubienia
29
Pobrania
57
Wydruki
0
Wyświetlenia
1429
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

I designed a monitor light bar for my desk. It's my first design so I am not an expert but all parts fit close to perfect.

Cable chain and nuts are not my projects so I refer to the pages:

https://www.printables.com/pl/model/310284-ender-3-s1-cable-chain

https://www.printables.com/pl/model/45286-tp-link-tapo-c100c110-mount

 

Parts to print

1 x Wall mount

1 x Arm with chain holder (supports required)

7 x Arm

8 x Nut

2 x Double Profile cover

4 x Profile holder

4 x Top profile holder

1 x Chain profile holder (supports required)

27 x Chain with clip

 

 

Additionally you will need:

1 x 1m or 2 x 0,5m  aluminium profile (dimmensions of mine - 27x4 x 10,5mm -  LUMINES type DUAL)

1 x milk or frozen cover or similiar

1 x 1m long M8 threaded rod (splited to smaller parts)

1 x 1m RGB CCT Led strip 

1 x 2m 6pin cable for Led strip

1 x Controller (Milight FUT039s) you can use whatever you like

1 x Desk pilot (MiLight RAINBOW S2-B) also you can use whatever you like

1 x 12V power adapter (matched to the power of the led strip - mine has 36W)

4 x m5 screw - 15mm long

 

 

How to mount:

Cut led strip into two equal sections and solder it together with 5cm long separated 6pin cable for led's. On the other side solder 2m long 6pin cable. There is a space for cables in part named ‘Double profile cover’

In a center of one aluminium profile closer to the side you must drill a 5 mm hole for cable and route them inside the profile (see wiring diagram).

To connect parts I used M8 threaded rod, cutted to the right dimmensions - about 3 x 110mm and 1 x 155mm. Part called ‘Chain profile holder’ is for mount a chain to cover ugly colored cable - simple press to the profile between ‘Double profile holder’.

Tagi