1 / 4
Bit Holder Remix for Williams WRS-1 Screwdriver
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bit holder for the WRS-1 screwdriver. This version has clips to hold the bits more securely, and it's parametrized!
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 221
- Wydruki
- 2
- Wyświetlenia
- 891
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 2) (Komentarze: 4)Remiksy (0)Kolekcje (20)Powiązane
This is a remix of johnzanussi's Williams Screwdriver Bit Holder. I liked the original bit holder a lot, but it didn't hold my bits tightly enough. So I made a couple improvements to hold the bits more securely.
Compared to the original:
- This model has clips that wrap around slightly to hold the bits more securely. You can feel them snap into place.
- The opening for the bits is ~0.5mm tighter to hold the bits more securely.
- The model was created in OpenSCAD so you can modify the parameters if you need to make adjustments for your printer.
Print Settings
- PLA worked well for me.
- Print vertically with organic supports in PrusaSlicer 2.6+.
- Other than that, your usual defaults are probably fine. I used 0.2mm layer height with 15% infill.
Troubleshooting
- If the scale is slightly wrong for your printer, you can use OpenSCAD to adjust the hex_bit_width or cap_diameter parameters and export a new STL.