1 / 4
Bit Holder Remix for Williams WRS-1 Screwdriver
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bit holder for the WRS-1 screwdriver. This version has clips to hold the bits more securely, and it's parametrized!
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 221
- Makes
- 2
- Views
- 891
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a remix of johnzanussi's Williams Screwdriver Bit Holder. I liked the original bit holder a lot, but it didn't hold my bits tightly enough. So I made a couple improvements to hold the bits more securely.
Compared to the original:
- This model has clips that wrap around slightly to hold the bits more securely. You can feel them snap into place.
- The opening for the bits is ~0.5mm tighter to hold the bits more securely.
- The model was created in OpenSCAD so you can modify the parameters if you need to make adjustments for your printer.
Print Settings
- PLA worked well for me.
- Print vertically with organic supports in PrusaSlicer 2.6+.
- Other than that, your usual defaults are probably fine. I used 0.2mm layer height with 15% infill.
Troubleshooting
- If the scale is slightly wrong for your printer, you can use OpenSCAD to adjust the hex_bit_width or cap_diameter parameters and export a new STL.