Skadis Fluke 101
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A design that can be 3D printed or laser cut to hold a Fluke 101 on an Ikea SKÅDIS pegboard.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 104
- Wydruki
- 0
- Wyświetlenia
- 938
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
The 3mf model is in the orientation expected for use. It will need to be laid flat for printing. The corners will need to be knocked off the top hook to fit properly. This makes the laser cut version fit much more nicely. I switched to 3d print only because my laser printer died as I was getting this job setup.
There are some things I might try changing in the future if I make another version.
- Make a version of the model with 1-2mm chamfers so it works right off the print bed. Alternatively just make the top hook slightly smaller.
- Add some sort of lateral support to the hooks. For now I'll probably end up gluing a couple pieces of foam board to it.
I used the dimensions from here: https://www.reddit.com/r/ikeahacks/comments/z4kxhz/ikea_skadis_sizes/
Also an excellent resource here: https://www.printables.com/model/228663-t-nuts-for-ikea-skadis-pegboards
My OnShape source: