1 / 5
LowRider 3 CNC SKR+Raspberry Pi Control Box
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed control box for the LowRider3 CNC for the SKR 1.x and Raspberry Pi 3
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1093
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (0)Kolekcje (18)Powiązane
This is a re-remix of Jeffeb3's remix of the LowRider3 CNC's control box. It enables mounting the SKR 1.3/1.4 controller, a Raspberry Pi 2B/3B/3B+, and LM2596 buck converter. Optionally, I also glued in 2 x Wago mounts to distribute power within the case. All screw holes are designed for M3 BHC.
Changes:
- Lengthened case by 20mm to accommodate additional hardware
- Shifted SKR board back to make room for cable routing on all sides of the PCB
- Added a 30x10mm fan to keep things inside the case cool(er)
- Rotated Raspberry Pi to externally expose ports and re-oriented to be parallel with the bottom of the case.
- Added mounting points for an LM2596 buck converter to power the Pi.
- Relocated V1 logo cutout to the right of the Pi to accommodate power ingress.
Note: The taller blue heatsinks that came with my stepper drivers were a little too tall for the lid to close without touching. I opted to use some lower-profile heatsinks to resolve the clearance issue.