Closet Space Savers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chain multiple hangers together in your closet to save space!
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 157
- Wydruki
- 2
- Wyświetlenia
- 607
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
You've probably already seen something like this on TV. You can easily chain multiple hangers together to save space on the pole in your closet. I wasn't about to buy these so I whipped up my own design and printed them out. They work like a charm! They work equally well for conventional wire hangers or the round plastic molded variety.
I printed these in PLA+ but Nylon might be a better fit for this project if you have it on hand. So far these work just fine and I have chained 6 shirts together without an issue.
The .STL file is set up to print these four at a time. I see no reason why you would want to print only one or two of these so that was the reasoning for setting it up as a multiple. Use the orientation that is in the .STL file for maximum strength. So far I haven't been able to break one of these by loading up the hangers. Your mileage may vary <grin>.
I used the following for the PLA+ parts:
- .4mm Nozzle
- .2mm layer height
- 4 layer top and bottom
- 4 perimeters
- 100% infill