Filament Guide for Creality Ender 3 Filament Runout Sensor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed the original since when it was downloaded, the sensor block, bracket, wheel, and spacers were one solid piece.
- Ocena
- 4,875 / 5
- Polubienia
- 45
- Pobrania
- 319
- Wydruki
- 9
- Wyświetlenia
- 1992
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I remixed the original since when it was downloaded, the sensor block, bracket, wheel, and spacers were one solid piece. I painstakingly separated each piece and compiled them for use.
This will fit on the Creality Ender3 V2 filament runout sensor.
You will need to print the following:
1 'filament runout sensor'
1 ‘wheel’
2 'spacer'
Filament Guide for Reality Ender 3 Filament Runout Sensor
Requires
- 1x 608 Bearing
- 1x M3 screw, at least 15mm long
- 2x M3 screws, at least 18mm long
Update: March 6, 2023
I now have a Spacer V2 which is the correct diameter for the M3 screw. I also have a bracket V2 which for some models might line up the filament more straight into the sensor.
Note: If the filament rubs on the bottom of the brass insert in the sensor, you will need the original version.
Don't forget to post your make and get your Prusameters! I love to see people's makes.