Dual output Hepa/carbon Filter for printer enclosure MARK 2 !
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual output Hepa/carbon Filter for LACK printer enclosure [SOON pictures of the installed thingie !] This is the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 235
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Dual output Hepa/carbon Filter for LACK printer enclosure
[SOON pictures of the installed thingie !]
This is the second design : this one should fit into the Lack table, the filterblock simply slide inside.
It's designed to fit a 120mm fan (in the motor block), a hepa filter and a carbon filter (in the drawer). I use an Arctic P12, which fits without screws. any other should do, I guess.
EDIT : Arctic P12 silent (1050 rpm) seems way too weak for hepa+carbon - it needs something which can run a little higher - will be tested soon.
Knob has to be fixed with 2 m3 bolts (30mm) and self-locking nuts, it will slide the slide piece to open or close the filter. It is the only piece that needs supports (for the nut holes)
The filter block has to be printed standing (rotate 90°), without support, if your printer can retract correctly, not like mine ;) ... It slides laterally into the fan case. The drawer comes inside the filter block.
Hepa used : https://www.amazon.de/gp/product/B09M1Z839Q/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&th=1
There are two designs of the motorblock and the knob cache : simple ones, and a second ones with some ziggy stardust design.
Category: 3D Printer Accessories