Anet E16 E12 Y-axis Rod Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 433
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.
They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they sit flush on the front and back of the printer frame. You can use an M3 nut and screw (18mm+) to hold the rods in place and prevent movement if your print tolerances aren't tight enough to hold them from friction alone.
I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use shorter countersunk screws if you want.
You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and clean up the holes with a drill if needed.
If you print with generated supports you'll likely weld the seam together with support material.
Print Settings
Printer:
Anet E16
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
40%+
Filament:
eSun PLA+Category: 3D Printer Parts