Anet E16 E12 Y-axis Rod Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 86
- Makes
- 1
- Views
- 433
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.
They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they sit flush on the front and back of the printer frame. You can use an M3 nut and screw (18mm+) to hold the rods in place and prevent movement if your print tolerances aren't tight enough to hold them from friction alone.
I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use shorter countersunk screws if you want.
You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and clean up the holes with a drill if needed.
If you print with generated supports you'll likely weld the seam together with support material.
Print Settings
Printer:
Anet E16
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
40%+
Filament:
eSun PLA+Category: 3D Printer Parts