Brewzilla 35/65L Gen 3 Glass Lid Bung
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bung to seal the hole in the glass lid during storage for the Kegland Brewzilla 35 & 65L Gen 3 brewing devices.
- Ocena
- 4 / 5
- Polubienia
- 15
- Pobrania
- 144
- Wydruki
- 3
- Wyświetlenia
- 722
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
What is this?
This is a basic bung I designed to seal the 40mm hole in the lid of the Brewzilla 35/65L Gen III all in one brewing device between brews, when it is in storage in my garage. Previously I was using masking tape, which was fine but a little wasteful and left residue. The garage is dusty and there are insects around, so it's necessary to seal it so it is ready to go straight away for the next brew. It fits very nicely, and has 4 small indentations around the perimeter to aid in removal.
It is essential to print this in a flexible filament, such as TPU, so that it can be flexed to pass through the hole, and be retained by the top and bottom ridges. My example is printed in Overture Green TPU, 0.2mm layers/0.4mm nozzle, 228/40C, 20% IF, 3 walls, 4 layers top/bottom, 120% flow, 20mm/s, no parts cooling fan, gluestick used, and a magnetic textured PEI sheet. Printer is a E3V2 with Mellow all metal hot end, capricorn tube, and Minimus fan shroud.
It is a snug fit, and honestly Kegland should have packaged the devices with one from factory.