Minimal Funko Pop Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic shelf for a single standard Funko Pop with protector
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 209
- Wydruki
- 2
- Wyświetlenia
- 1565
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
While there is no shortage of Funko Pop organizers, shelves, etc., online, none of them were exactly what I wanted. So, I drew up this very simple design.
Printed at 100%, it fits snugly around a standard Funko Pop figure in box with one of the collapsible pop protectors. This was not designed to fit the hard box protectors.
I printed at 0.2mm 100% infill because I used translucent filament. If printing opaque, 20% infill is probably fine. There likely isn't all that big a difference in filament used, though.
I simply attached to the wall with 3M command strips. Funko Pop figures don't weigh much so you could use just about any sort of adhesive mounting you prefer.