Hue Outdoor Motion Sensor Ceiling Mount v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Re-upload from Lewis Roberts (lwsrbrts) at Thingiverse (see linked below) without alterations of the models.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 529
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Rotate the cap and main body appropriately: 180 degress for the cap, 90 degrees (on its back) for the main body.
The cap can be screwed to the ceiling with a single 3.5mm countersunk screw, allowing it to be oriented to the desired direction also.
The main body then just clips in to the cap. It can be further secured using a tie-wrap (zip-tie) or a small nut/bolt if desired because of the through-hole.
Use supports when printing.
There's a removal tool included to use with pliers but you should only need to squeeze the cap with full-size (not needle nose) pliers and a firm(ish) pull to release the cap from the main body.
Print Settings
- Supports: Yes
- Resolution: 0.2
- Infill: 10%
- Notes: Supports are required to print both the main body and cap.