Hue Outdoor Motion Sensor Ceiling Mount v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Re-upload from Lewis Roberts (lwsrbrts) at Thingiverse (see linked below) without alterations of the models.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 27
- Makes
- 0
- Views
- 526
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Rotate the cap and main body appropriately: 180 degress for the cap, 90 degrees (on its back) for the main body.
The cap can be screwed to the ceiling with a single 3.5mm countersunk screw, allowing it to be oriented to the desired direction also.
The main body then just clips in to the cap. It can be further secured using a tie-wrap (zip-tie) or a small nut/bolt if desired because of the through-hole.
Use supports when printing.
There's a removal tool included to use with pliers but you should only need to squeeze the cap with full-size (not needle nose) pliers and a firm(ish) pull to release the cap from the main body.
Print Settings
- Supports: Yes
- Resolution: 0.2
- Infill: 10%
- Notes: Supports are required to print both the main body and cap.