Manual bed leveling and tramming aid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
STL that helps with tramming the bed manually for the perfect print!
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 347
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
This model helps with tramming (leveling) the bed of your printer, as long as you have the turning knobs under the bed. This model can also be used for adjusting z offset for the perfect first layer, depending on how you slice it.
This is how I use it:
Layer height: 0.2 mm
Line width: 0.4 mm (nozzle width)
Number of walls: 20 (or more)
Print speed 30 mm/s
Tram (level) the bed manually like you normally will do, using a piece of paper on each corner of the bed, adjusting the knobs until the bed is perfect. Set the z offset like you normally do.
Now you print this file, with high wall count. Also, go slow!! The whole point is to watch the printer work, and fine tune each corner on the fly. It is best to turn the knobs maximum ¼ turn at the time, until you get it to print consistently all the way around.
The model is made without sharp corners, so it prints each wall continuously.