Taiko force lv.5 - Bachi Holder

I wanted to store my bachi with the taiko. If I left them separate I'm sure I would lose them sooner then later. But not anymore!

Disclaimer: I am not responsible for anything going wrong with either your drum, bachi or parts thereof.

You may also be interested in control box brackets: https://www.printables.com/model/630766-taiko-force-lv5-control-box-brackets-with-simple-s

23mm diameter bachi is the maximum this will hold! (That is the wood with grip tape applied)

How to install:

1. Print holder (Any reasonable settings will do. Larger layers will speed up the print time significantly).
2. Put bachi into the holder and put it on one of the legs. When satisfied with the position remove bachi and mark the holes with pencil.
3. Remove leg from taiko.
4. You have two options (Use M4 flat face bolts):
   1.  Drill 3mm hole, then tap 4mm threads (or drill 3.5mm hole and use the bolt itself to tap). Then screw the holder into the leg.
   2. Drill 4-4.5mm hole, then use nuts and washers from the other side
5. Reassemble taiko
6. Enjoy