ADSM302 Microphone Arm Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Microphone arm mount for ADSM302 or similar microscopes with up to 35mm in mount diameter.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 85
- Wydruki
- 1
- Wyświetlenia
- 1479
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
Microphone arm mount for ADSM302 or similar microscopes with up to 35mm in mount diameter.
You will need:
3 x M3 square nuts
3 x M3x10 or similar screws
1 x M3x40 mm or similar screw
These parts should be familiar to Prusa owners and will still be in the spare bag.
Drop in the 3 nuts into the slots from above and screw in the short screws to hold your scope.
The longer M3x40mm screw goes through the longer arm piece from the inside. Just screw it as far as it will go. This will act as a stiffener for the arm and will prevent you ripping your holder off when you move the microphone stand by the scope itself.
The arm shown here is a cheap Tonor T20.
If you need one of my things printed or you want to suggest a modification on a part please drop me a message!
If you print one of my things i would be happy about some feedback and a make!
If you like my things please consider supporting my caffeine addiction!
Print instructions
Printer Brand: Prusa
Printer: I3 MK3S
Supports: No
Resolution: 0.15
Infill: 100%