1 / 4
Channeled Marble Towel Hook — zdjęcie 1
1 / 4

Channeled Marble Towel Hook

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A stylish “hook” to hang our shower mat/towel for drying.

Ocena
0 / 5
Polubienia
11
Pobrania
67
Wydruki
0
Wyświetlenia
705
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution

Summary
My wife asked me if I could design and 3D print a “hook” to hang our shower mat/towel for drying. I wanted something that wasn't going to protrude out too far from the wall or that something could be caught on. After searching around, I discovered the idea of an internal ball hook and came up with this design.

This design utilizes a 15.8mm diameter glass marble, which I assume is a common size since I had several of them laying around.

I made this particular towel holder with 2.5mm in clearance which is the thickness of the border on my shower mat. This gap should be enough to work properly with a standard bath or hand towel, as well.

Print Settings
Printer brand:
Prusa

Printer:
I3 MK3S

Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
15%
Filament brand:
3D Solutech

Filament color:
White

Filament material:
PLA

Notes:
Insert a pause at 50.00mm during printing in order to insert marble into model

Post-Printing
Use Instructions
Installation

I used Gorilla Tough & Clear Double Sided Adhesive Mounting Tape along the full length of the back of the hook, peeled, and stuck to wall

How to hang towel

Place the edge of the towel into the hood from below and lift up into the clamp
Pull down on the towel allowing the marble to grip it and lodge into its lower position
How to remove towel

Pull the towel upward and off to the side to dislodge the marble while sliding the towel away out of the hook