1 / 4
Channeled Marble Towel Hook — image 1
1 / 4

Channeled Marble Towel Hook

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A stylish “hook” to hang our shower mat/towel for drying.

Rating
0 / 5
Likes
11
Downloads
67
Makes
0
Views
705
Reviews
0

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution

Summary
My wife asked me if I could design and 3D print a “hook” to hang our shower mat/towel for drying. I wanted something that wasn't going to protrude out too far from the wall or that something could be caught on. After searching around, I discovered the idea of an internal ball hook and came up with this design.

This design utilizes a 15.8mm diameter glass marble, which I assume is a common size since I had several of them laying around.

I made this particular towel holder with 2.5mm in clearance which is the thickness of the border on my shower mat. This gap should be enough to work properly with a standard bath or hand towel, as well.

Print Settings
Printer brand:
Prusa

Printer:
I3 MK3S

Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
15%
Filament brand:
3D Solutech

Filament color:
White

Filament material:
PLA

Notes:
Insert a pause at 50.00mm during printing in order to insert marble into model

Post-Printing
Use Instructions
Installation

I used Gorilla Tough & Clear Double Sided Adhesive Mounting Tape along the full length of the back of the hook, peeled, and stuck to wall

How to hang towel

Place the edge of the towel into the hood from below and lift up into the clamp
Pull down on the towel allowing the marble to grip it and lodge into its lower position
How to remove towel

Pull the towel upward and off to the side to dislodge the marble while sliding the towel away out of the hook