1 / 1
Moen Towel Bar - Paper Holder Mount (Eva Series + Others) — zdjęcie 1

Moen Towel Bar - Paper Holder Mount (Eva Series + Others)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mounting bracket for Moen towel bar (Eva design series)

Ocena
5 / 5
Polubienia
2
Pobrania
95
Wydruki
1
Wyświetlenia
631
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution

Summary
I had a failure of one of the wall mounts for my Moen Eva towel bar. After scouring the web and calling Moen, the part alone is not available (you must re-purchase the entire item if not under warranty). So, I took some time and designed this mount which works perfectly as a replacement. Please note that not all Moen products use the same mount. This one works specifically with the Eva models and whatever else uses this mount type.

You must use PETG to print this part. I printed a few tests with PLA, and the tab breaks off with the slightest pressing. However, the PETG is quite strong and offer plenty of flex to work as designed.

I did print with build plate support but only for the area just below the tab (I didn't want support material behind the tab in the open area where it would be very difficult to remove without damaging the part.

Also, this part is designed to print using 100% infill. You might be able to get away with less, but I'll leave that up to you.

Unfortunately, I forgot to take a photo before I installed, but may add one at a later time.

Print Settings
Printer brand:
Prusa

Printer:
I3 MK3S

Rafts:
No
Supports:
No
Resolution:
.2 mm
Infill:
100%
Filament brand:
Prusament

Filament color:
Black

Filament material:
PETG