1 / 1
Moen Towel Bar - Paper Holder Mount (Eva Series + Others) — image 1

Moen Towel Bar - Paper Holder Mount (Eva Series + Others)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mounting bracket for Moen towel bar (Eva design series)

Rating
5 / 5
Likes
2
Downloads
95
Makes
1
Views
631
Reviews
1

Updated at source:

Model information

Category
Bathroom
License
Creative Commons — Attribution

Summary
I had a failure of one of the wall mounts for my Moen Eva towel bar. After scouring the web and calling Moen, the part alone is not available (you must re-purchase the entire item if not under warranty). So, I took some time and designed this mount which works perfectly as a replacement. Please note that not all Moen products use the same mount. This one works specifically with the Eva models and whatever else uses this mount type.

You must use PETG to print this part. I printed a few tests with PLA, and the tab breaks off with the slightest pressing. However, the PETG is quite strong and offer plenty of flex to work as designed.

I did print with build plate support but only for the area just below the tab (I didn't want support material behind the tab in the open area where it would be very difficult to remove without damaging the part.

Also, this part is designed to print using 100% infill. You might be able to get away with less, but I'll leave that up to you.

Unfortunately, I forgot to take a photo before I installed, but may add one at a later time.

Print Settings
Printer brand:
Prusa

Printer:
I3 MK3S

Rafts:
No
Supports:
No
Resolution:
.2 mm
Infill:
100%
Filament brand:
Prusament

Filament color:
Black

Filament material:
PETG