LILYGO T-Display-S3 for fischertechnik
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the cute LILYGO T-Display-S3 ESP32 module with its ultra fast and sharp TFT display
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 90
- Wydruki
- 1
- Wyświetlenia
- 1480
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A case for the cute LILYGO T-Display-S3 ESP32 module with its ultra fast and sharp TFT display (without touch version), with compatible connectors for fischertechnik.
Two I2C connectors at the back need a 2x9 strip of perfboard and two 2x3 (or four 1x3) pin headers. You can use any free pins, I used IO43 as SDA and IO44 as SCL.
To access the reset button, you'll need to cut the tiny bridge that helps you print the part without supports.
The module's pin headers are accessible at the bottom side. They will also allow direct connection of ft plugs, using a variant of the printbuchse design. Their connection will be most stable if you connect plugs to both sides and/or insert an extra ft plug holder strip on both sides.
Use a 2mm screw to fasten the module from the bottom side. My module unfortunately came with only one hole in the PCB, even if the acrylic frame has two. That's why I provided a hole for an optional second screw but hid it under a thin 0.2mm layer, simply push it through if your PCB has both holes.
Please leave a "like" or post your make as a token of appreciation for my work.
Find my other fischertechnik designs here.
Category: Electronics