Threadable long 10-32 nut (MSD Start and Step)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
This is a 10-32 threadable nut with a flat blade screwdriver slot at the top for tightening. I designed it for a location where there is very little room to get a wrench around a traditional nut, so it was easier to make a part to get it up and out of the way. You could probably also do 10-24 threads with no issue as the size of the hole is pretty close on the bottom.
The hole on the bottom is 28mm deep, so you can fit a good size stud in this if you needed to. Recommend when threading use a bit of cutting oil or just WD-40. I printed these in PETG and they tended to gum up the tap a little bit without it.
I have these on an MSD Start and Step that is in a pretty tough to reach area under the dash
Printed in PETG with 100% infill for strength.