Fallout Holotape Replica
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fallout 3 / Fallout: New Vegas [inspired] holotape model.
- Ocena
- 5 / 5
- Polubienia
- 248
- Pobrania
- 548
- Wydruki
- 9
- Wyświetlenia
- 3395
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution
Nothing super fancy here, just a few pieces.
The bottom/base, the red “wire” part, the tape rolls and strip piece, the reels, and of course the top piece.
You'll need 4 M3 x 12mm screws and 4 nuts.
The red “wire” piece and the strip of tape just need a touch of glue.
Notes of caution/advice:
- You will most likely need to widen the center holes on the tape rolls. I just took a tiny strip of sandpaper (400grit), rolled it up, and ran it through the holes for like 30 seconds each.
- The cutouts for the M3 nuts on the base have super tight tolerances. I balance a nut on top of each hole and use a pair of vice grips (the locking pliers) to gently press the hardware in.