Fallout Holotape Replica
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fallout 3 / Fallout: New Vegas [inspired] holotape model.
- Rating
- 5 / 5
- Likes
- 248
- Downloads
- 548
- Makes
- 9
- Views
- 3,395
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution
Nothing super fancy here, just a few pieces.
The bottom/base, the red “wire” part, the tape rolls and strip piece, the reels, and of course the top piece.
You'll need 4 M3 x 12mm screws and 4 nuts.
The red “wire” piece and the strip of tape just need a touch of glue.
Notes of caution/advice:
- You will most likely need to widen the center holes on the tape rolls. I just took a tiny strip of sandpaper (400grit), rolled it up, and ran it through the holes for like 30 seconds each.
- The cutouts for the M3 nuts on the base have super tight tolerances. I balance a nut on top of each hole and use a pair of vice grips (the locking pliers) to gently press the hardware in.