Raspberry PI 4 Double Flirc Case Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holder was designed to keep my Raspberry PI 4 boards stacked firmly together while using the FLIRC case.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 812
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This holder was designed to keep my Raspberry PI 4 boards stacked firmly together while using the FLIRC case.
All rear ports are accessible. However, top ports are covered except the USB-C. The reason is that I use my RPi boards in headless configuration, thus those mini-HDMIs are not needed.
The whole case consists of 2 parts:
- the main body
- the top lid
The top lid has 2 rails so it can be attached to the main body easily by sliding.
Please, use the PLA filament. There are minimal tolerances, so other materials may cause problems.
Print instructions
Printer: Original Prusa Mini
Rafts: No
Supports: No
Resolution: 0.15 mm
Infill: 15%
Filament: Filament PM Pearl Red
Filament Type: PLA