LED Lightbar prusa mk3 mk3s mk3s+ remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of lightbar to fit these LEDs: https://www.amazon.com/LEDENET-Double-1200LEDs-Flexible-240LEDs/dp/B00NHRFAQW/
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 92
- Wydruki
- 3
- Wyświetlenia
- 672
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really liked dubs49's design. Unfortunately, a quick print of a cross section of their bar showed it wouldn't fit the LEDs I had on hand. So I redesigned the bar from scratch to use the leds I really wanted to use. https://www.amazon.com/LEDENET-Double-1200LEDs-Flexible-240LEDs/dp/B00NHRFAQW/
Knowing how “secure” the adhesive is on LED strips, I added some retaining clips as well. These clips are quite tight as I didn't want them rattling while printing. I slid them on from the side while sliding in the LED strip. These clips provide enough pressure that I didn't use the adhesive backing.
The original source model was not provided and I really liked dubs49's design of the mounting arms, so I didn't remodel that. Perhaps I will do that eventually, but I'm ok with the slight under-hang of the lightbar.
Assemble the bar with M3 nuts (it's tight, but it fits!) and M3x14 bolts with a thin washer on top.
PETG 0.25 45% infill