Spoolbracket Upgrade (Anycubic Kobra)

UPDATE 07.08.2023

added two new parts:

• endcap_duo_simplifiedx70mm (for “holder+20mm”)
• endcap_duo_simplifiedx90mm (for “holder”)

these allow the spoolbracket to be mounted on the anycubic kobra plus aswell.

See therefor:

https://www.printables.com/de/model/426119-universalmodular-spoolholder-integrated-bearing

UPDATE 19.07.2023

added additional spoolbracket_+30mm_height which provides filament spools up to 255mm in diameter.

----------------------------------------------------------------------------------------------------------------

UPDATE 15.07.2023

recently added following parts:

• spoolbracket_+10mm_height
• endcap_duo_simplified_-10mm_length

In case you have slightly larger and wider spools that won't fit with the original parts.

“endcap_duo_simplified_-10mm_length” allows using the “holder+20mm.STL” from

https://www.printables.com/de/model/426119-universalmodular-spoolholder-integrated-bearing/files

Upgraded spoolbrackets for the Anycubic Kobra, which provides the following:

• Spool is completly centered above the printer and turned by 90°
• new brackets are far less wobbly then the standard metal one
• spool can easily and quickly be removed from the printer
• max. spool diameter: 195mm

Parts for Brackets:*

• 2x spoolbracket.stl
• 4x centering.stl (if not using screws, i recommend to glue them into spoolbracket)

Parts for Spoolholders [2 Options]:

Option 1:

• https://www.printables.com/de/model/426119-universalmodular-spoolholder

Option 2:

• Simplified Spoolholder
• Parts List:
  • 1x holder.stl (from universal/modular spoolholder)
  • 2x clamp.stl (from universal/modular spoolholder)
  • 2x endcap_duo_simplified

*Optional:

• 4x M5x40 cylinderhead  - the brackets work fine without any screws, if you still prefer to screw it on top of the printer, the brackets are ready for this and just replace the original too short screws from the printer. (make sure, you also use the screw locks from the original printer mounting - these can be found under the 4 top screws from the printer)

All parts were printed with 0.2mm layer height, 15% infill, 50mm/s, PLA 200°/60° and support, where needed. (no supports needed for the threads with theses parameters!)

See slicerpictures for  print - orientation.