Brewzilla 35/65L Gen 3 Malt Pipe Bung
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bung to seal the malt pipe during storage for the Kegland Brewzilla 35 & 65L Gen 3 brewing devices.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 96
- Wydruki
- 1
- Wyświetlenia
- 678
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
What is this?
This is a basic bung I designed to seal the 25mm opening in the ball valve of the malt pipe of the Brewzilla 35/65L Gen III all in one brewing device between brews, when it is in storage in my garage. Previously I was using a plastic bag, which was fine but a bit sloppy. The garage is dusty and there are insects around, so it's necessary to seal it so it is ready to go straight away for the next brew. It fits very nicely, and easy to get a finger under the lip for removal.
It is essential to print this in a flexible filament, such as TPU, so that it can be flexed to pull out of the hole, and so the ridges press against in the inside of the opening. My example is printed in Overture Green TPU (Shore Hardness 95A), 0.2mm layers/0.4mm nozzle, 228/40C, 20% IF, 3 walls, 4 layers top/bottom, 120% flow, 20mm/s, no parts cooling fan, gluestick used, and a magnetic textured PEI sheet. Printed on a E3V2 with Mellow all metal hot end and hardened steel nozzle, capricorn tube, and Minimus fan shroud.