V2.4 Skirt Fan Breakout Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for small fan breakout PCB which fits in the hex grid of the side fan supports on the Voron V2.4
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 332
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Kind of a hack but I wanted to reduce my electronics cooling fan noise and keep it modular. Here is a mount for attaching an improvised breakout board using a cut down 20mm x 80mm PCB prototype board to the side fan support.
The mount uses two of the mounting holes on the PCB and one drilled out through-hole to attach with M2 screws threaded into the plastic. I trimmed the PCB into a bow-tie to hide it better from outside view. The mount had a good friction fit into the hex holes but I glued it in for good measure. If I ditch this mod I can always print a new side fan support.
I used a buck step-down converter with appropriate current capacity because that's what I had but it could easily just be potentiometer or some resistors if you don't want variability.