1 / 16
Artillery Evnovo Sidewinder X2, Z, Achse, Verstrebung, Arretierung, Justierung — zdjęcie 1
1 / 16

Artillery Evnovo Sidewinder X2, Z, Achse, Verstrebung, Arretierung, Justierung

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Das Problem, das die Z-Achse sehr schwingt, ist trotz einiger Modifikationen geblieben. Das ist gleich meine erste…

Ocena
4 / 5
Polubienia
24
Pobrania
96
Wydruki
3
Wyświetlenia
1280
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Das Problem, das die Z-Achse sehr schwingt, ist trotz einiger Modifikationen geblieben. Das ist gleich meine erste Ergänzung, die ich wieder anbaue. Das hat mir schon beim X1 mehr Sicherheit gegeben. Ich habe dazu meine Vorlage der Diagonalverstrebung mit den Teilen für den Sidewinder X2 ergänzt. https://www.thingiverse.com/thing:4581346

Man kann alle Teile vom X1 verwenden bis auf die oberen Halterungen, die ja nun an den neuen Steg angepasst wurden.

Um die Garantie zu erhalten, verwende ich vorerst nur die hintere Verstrebung. Hier habe ich auch einen den unteren Halter neu konstruiert, sodass man den Drucker nicht öffnen muss. Die Halterung wird nur aufgesteckt. Verklemmt sich am Unterboden und wird oben mit den original Schrauben befestigt.

Material

PLA ca. 52 m

Befestigung am Drucker - original Schrauben

2x Gewindestange M10 ca. 58 cm

4x Schrauben M5 20 mm

4x Muttern M5


The problem that the Z-axis vibrates a lot has remained despite some modifications. This is immediately my first addition, which I attach again. This has already given me more security with the X1. I have supplemented my template of the diagonal brace with the parts for the Sidewinder X2. https://www.thingiverse.com/thing:4581346

You can use all parts from the X1 except for the upper brackets, which have now been adapted to the new stay.

To preserve the warranty, I'm only using the rear strut for now. Here I also redesigned the lower bracket so you don't have to open the printer. The holder is only plugged on. Clamps to the underbody and is fixed at the top with the original screws.

Material

PLA approx. 52 m

Fastening to the printer - original screws

2x threaded rod M10 approx. 58 cm

4x screws M5 20 mm

4x nuts M5

Print Settings

Printer:

Sidewinder X / Genius

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament:

No Name PLA

black


Notes:

Ich habe für die größeren Teile eine 0,8 Nozzle und Layer 0,32 verwendet um schneller ein Ergebnis zu erhalten. Eine geringere Layerhöhe bringt allerdings mehr Ästhetik.
Für die Gewindeteile hingegen habe ich eine 0,4 Nozzle und Layer 0,2 benutzt.

Category: 3D Printer Accessories

Tagi