1 / 4
Mitsubishi Outlander REMCU DC Cable Gland
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Many used Outlander Inverters don't come with cable pigtails, with this gland you can replace it with generic connector.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 893
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (11)Powiązane
This gland can be used for the DC supply lines
Versions
- With supports: The “skirt” and added layer above that covering the 6mm hole enable a print without further support. If the perimeters are printed from the inside out, the O-Ring groove can be printed without supports as well.
- Without supports: Add your own supports :)
- M16: For small diameter cables.
- M20: For larger diameter cables.
Recommended Material & Print Settings
- 0.1mm Layer height for good thread resolution
- The M16x1.5/M20x1.5 thread can be tight if there is too much extrusion
- The test prints were made with PLA and PETG, if you want to use it in a car better use ABS, PETG, …
- The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.
Additional Hardware
- 18x3mm or 18.5mm O-Ring
- M16/M20 cable gland
Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.
Updates
28.04.2022: The v10 version has a deeper threaded hole to accomodate different style cable glands better.