1 / 4
Mitsubishi Outlander REMCU DC Cable Gland
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Many used Outlander Inverters don't come with cable pigtails, with this gland you can replace it with generic connector.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 48
- Makes
- 1
- Views
- 893
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
This gland can be used for the DC supply lines
Versions
- With supports: The “skirt” and added layer above that covering the 6mm hole enable a print without further support. If the perimeters are printed from the inside out, the O-Ring groove can be printed without supports as well.
- Without supports: Add your own supports :)
- M16: For small diameter cables.
- M20: For larger diameter cables.
Recommended Material & Print Settings
- 0.1mm Layer height for good thread resolution
- The M16x1.5/M20x1.5 thread can be tight if there is too much extrusion
- The test prints were made with PLA and PETG, if you want to use it in a car better use ABS, PETG, …
- The O-Ring groove usually does not need support if you have enough outer perimeters (at least on the layer above the groove) and print them from the inside out.
Additional Hardware
- 18x3mm or 18.5mm O-Ring
- M16/M20 cable gland
Please consider liking the model and posting a Make. It took a lot of revisions and a lot of filament and O-rings to get this right.
Updates
28.04.2022: The v10 version has a deeper threaded hole to accomodate different style cable glands better.