1 / 9
Dryer Ball Rack
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I would print with the top face down to make the jigsaw pieces fit snugly as well as to ensure the filet on the bottom…
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 24
- Wydruki
- 1
- Wyświetlenia
- 504
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (10)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (16)Powiązane
I would print with the top face down to make the jigsaw pieces fit snugly as well as to ensure the filet on the bottom has a good finish, as that's what most will see if you've got the shelf above eye level like I do.
The shelf is designed to fit shelving where:
- the pegs are 5mm in diameter
- the horizontal distance between both pegs is 240mm
- the vertical distance between peg layers is 32.75mm
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
No
Resolution:
0.20
Infill:
20%
Filament: eSUN PLA+ Black Post-Printing =============
Assembly
- 7mm peg goes between the top rear hole in the support and the shelf 16mm peg goes between the top front hole in the support and the shelf 16mm peg goes between the rear bottom hole in the support and the wall 23mm peg goes between the rear hole in the shelf and the wall
Category: Organization