Hackerbox 0089 WiSpy Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case I designed for the Hackerbox 0089 WiSpy project.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 611
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created this case for the Hackerbox 0089 WiSpy project.
As I use sockets rather than mounting the components directly to the PCB (so I can swap and/or reuse components), they sit a bit higher. I've designed the case openings for the MicroSD card and the two USB ports to account for using either method (PCB or socket mount).
The case has screw mount posts for the PCB, which will fit M2*5 Phillips screws (used for laptop repair) just fine (see pictures).
The smaller PCB that the project comes with, holds the OLED and the 2 antennas, so the case was designed for that to mount directly to the front. I left off the 2 locking/friction washers, while still using the 2 pressure washers, so that there would be enough of the female connector for the antennas to connect to.
I used Inland PLA Pro (similar to PLA+), printed at .2mm with 30% infill. No supports.
Links:
- Hackerbox 0089 Product Page
- Hackerbox 0089 Instructables
- JHewitt's WarDriver Rev3 Firmware GitHb
- Phillips Pan Head Self-Tapping Screws
- Inland PLA+ Filament