1 / 7
Turbine 40mm Fume Extractor
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 40mm fume extractor that sits on your desk or can be hung from a helping hand. For use with ONLY 40x20mm fans.
- Ocena
- 4,5 / 5
- Polubienia
- 33
- Pobrania
- 101
- Wydruki
- 1
- Wyświetlenia
- 1342
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (46)Powiązane
A fun and clean-looking fume extractor for your soldering setup. It uses a 40x20mm fan, the one I used was from Noctua. It should work with any other 40x20mm fan.
IMPORTANT: Make sure the fan you use is 5V, because that is the output of a standard USB cable.
Print Settings
Layer height: 0.24mm
Temperature: 245C and 70C
Material: PET-G
Walls: 3
Top/Bottom: 3
Infill: 20% Cubic
Speed: 60mm/s
Supports: Yes, change minimum angle from default 50 degrees to 80 degrees
Assembly
- Remove the supports from the back-piece
- Insert the 40mm fan into the front-piece
- If done correctly, the sticker on the back of the fan should be facing towards you (see 7th picture)
- Run the cable of the fan through the hexagon-mesh panel of the back-piece. There should be a larger hexagon cutout for the cable to pass through.
- Snap the back piece and front piece together by aligning the prongs and cutouts and then pushing them together. If your printer is well-tuned, they should snap into place and stay there with no wiggle.
- Strip a USB cable and solder the red and black wires from the fan to the red and black wires from the USB.
- Lastly, connect the USB to any power outlet, laptop, PC, or electronic, and the fan should turn on.
- Enjoy!