1 / 3
Pinecil/TS100 Gridfinity 1x1 soldering iron stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A space-saving solution for securing your soldering stick.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 1760
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (1)Kolekcje (50)Powiązane
This model uses the same 3ml silicone jars as Zack Freedman's original “Gridfinity Pinecil and TS100 Super Stand”. However, it holds the iron much more upright, occupying a single grid space. Works with short and standard TS100 tips.
- Print one base, one top, and four pegs.
- Assemble with a few small drops of CA glue. I recommend clamping for a few minutes to keep things square.
- Cut a cross in the base of one of the jars, and snap it into place on top of the model.
- Place a jar lid in the base of the model, and another jar base on top of that.
- Bonus: Cut out the top of another jar lid, and snap it on top of the jar base for a slightly more finished look. I did the rough cutting with a utility knife, and finished it with sandpaper.
As always, use common sense with your hot soldering iron. This model does a decent job of retaining the iron if it does tip over. However, it should still be secured to a baseplate using magnets, screws, or glue.
Other models pictured: