Birb Glider 3000
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2-piece hand-release bird-inspired air glider.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 472
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
A lightweight 2-piece “Birb” glider plane. Prints in 2 parts, the “front section” and the “tail section”. The 2-pieces fit together thru the tube body. Takes about 14-16 hours total. I used tape to secure the two-pieces together. There are thru-holes on the top and side of the tube fuselage of the front section for wires if you want to add a micromotor and battery case. If micro-motor(s) are attached, use double-stick or electrical tape to secure and place the battery pack on top-middle area of the front section. A micro-motor can be added to the inside of the front tube of the tail section.
In my photos, I had to place the 2-pieces together backwards because of an error during printing but it still flies/glides.
No supports are needed for the 2 prints.