1 / 3
Slide-on USB Hub stand for skinny and topple-prone hubs — zdjęcie 1
1 / 3

Slide-on USB Hub stand for skinny and topple-prone hubs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My USB hub kept toppling over as I added more cords and accessories. The fan especially caused it to want to lean.

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
306
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My USB hub was leaning and would topple when I added more than a few cords or accessories. 

This simple slip-on stand keeps it upright. Four worked for my setup, but you can likely get by with fewer.

I printed mine with a .6 nozzle and PLA, but it should work fine with a .4.


Made for a hub with the following dimensions (see photo):
Width: 35mm
Side height: 12mm
Upper (angled) width: 10mm
Angle: 135 degrees
 

Tagi