1 / 3
Slide-on USB Hub stand for skinny and topple-prone hubs
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My USB hub kept toppling over as I added more cords and accessories. The fan especially caused it to want to lean.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 305
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My USB hub was leaning and would topple when I added more than a few cords or accessories.
This simple slip-on stand keeps it upright. Four worked for my setup, but you can likely get by with fewer.
I printed mine with a .6 nozzle and PLA, but it should work fine with a .4.
Made for a hub with the following dimensions (see photo):
Width: 35mm
Side height: 12mm
Upper (angled) width: 10mm
Angle: 135 degrees