1 / 3
Makita DVC750 "No Pain" Handle - Better Carriage Handle for Cordless Portable Vacuum Cleaner
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A carriage handle that you no longer pinch your fingers on.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 599
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
The vacuum cleaner is great, except for one small detail: you regularly jam your fingers on the carriage handle. Probably happened to everyone who has ever worked with the vacuum cleaner. Here is the solution.
Instructions
- Print both parts
- Insert 4 filament pieces for alignment
- Glue both parts together with super glue. Do not apply glue in the area of the filament pieces
- Open battery compartment completely
- Remove the original handle. Position the screwdriver as shown in the picture and carefully push it towards the center of the unit.
- Install new handle.
- Close battery compartment
- Smile because you won't pinch your fingers so easily anymore
Print Settings:
- 3 Perimeters at 0.6mm Extrusionwidth
- Variable Layerheight (0-9,5mm 0,30mm / 9,5-12mm 0,20mm / 12mm- 0,10mm)
- 3 Bottomlayers
- 4 Toplayers
- 20% Gyroid Infil
Printed in eSUN ABS+
Used filament ~80g
Print Time ~2h30m
Remember: If you do this and something breaks or if someone gets hurt, it is fully your responsibility. I take no responsibility.