1 / 1
Vase mode remix of Jack Hydrazine's Enerjet fin can — zdjęcie 1

Vase mode remix of Jack Hydrazine's Enerjet fin can

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Made it vase mode and cleaned up things slicers don't like (low angle razor edges)

Ocena
0 / 5
Polubienia
3
Pobrania
29
Wydruki
0
Wyświetlenia
206
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Share Alike

I fixed up and remixed the Enerjet fin can. it has an chevron airfoil prints in vase mode and I took a little liberty with the fin shape to make it a wee more printable (the overhang was strong on this one :-)

Make sure to use a brim and I suggest a LOW layer height. 0.1mm for the bottom of the fin can. once you reach where the fins stops expanding and its straightens up then you can go back to 0.2 or maybe even 0.3mm layer height.

I also made 3 5 and 12 fin versions just for shiggles. being in vase mode they are light.

Set your EM to 1.0 single wall vase mode no top no bottom layers.