Vase mode remix of Jack Hydrazine's Enerjet fin can
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made it vase mode and cleaned up things slicers don't like (low angle razor edges)
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 29
- Makes
- 0
- Views
- 206
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Share Alike
I fixed up and remixed the Enerjet fin can. it has an chevron airfoil prints in vase mode and I took a little liberty with the fin shape to make it a wee more printable (the overhang was strong on this one :-)
Make sure to use a brim and I suggest a LOW layer height. 0.1mm for the bottom of the fin can. once you reach where the fins stops expanding and its straightens up then you can go back to 0.2 or maybe even 0.3mm layer height.
I also made 3 5 and 12 fin versions just for shiggles. being in vase mode they are light.
Set your EM to 1.0 single wall vase mode no top no bottom layers.