Tamiya Vanquish Front Upright
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Front Upright / Steering Arm
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 444
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Front upright/steering arm for Tamiya Vanquish.
It will also probably fit the Avant, Egress & Vajra.
I made this because the steering arm broke after a minor collision with a wall.
This should be stronger than the original.
The holes for the bearings may be a bit small, so you may need to file it (I used a Dremel) until the bearing fits tightly. Make sure you push the bearings all the way in (otherwise the circlip will not go on).
UPDATE (August 2017): I have updated it to v2. Now the bearing holes are a fraction bigger (increased diameter from 10.92mm to 11.0mm). You may still need to file the hole or heat up the piece to make the bearing fit.
UPDATE (April 2023): I have updated it to v3.
It is a bit stronger than before.
Also you need to have the part-cooling fan on between the layers from 4.6mm to 5.0mm for better bridging.
Then you can poke out the hole afterwards.
I created this in Google Sketchup 2020 and I have included the skp file (RHS only. Just flip it on the green or red axis to get LHS).